Novamatic FH67-VCU Instrukcja Użytkownika Pobierz pdf (Strona 22)

1.

Install the anti-tilt protection 317 - 322

mm down from the top surface of the

appliance and 80 - 85 mm from the

side of the appliance into the circular

hole on a bracket. Screw it into the solid

material or use applicable reinforcement

(wall).

80-85

mm

317-322

mm

2. You can find the hole on the left side at

the back of the appliance. Lift the front

of the appliance and put it in the middle

of the space between the cupboards. If

the space between the bench

cupboards is larger than the width of

the appliance, you must adjust the side

measurement to centre the appliance.

If you changed the dimensions

of the cooker, you must align

the non-tip device correctly.

CAUTION! If the space

between the bench cupboards

is larger than the width of the

appliance, you must adjust the

side measurement to the center

of the appliance.

Electrical installation

WARNING! The manufacturer is

not responsible if you do not

follow the safety precautions

from Safety chapters.

This appliance is supplied without a main

plug or a main cable.

Applicable cable type: H05 RR-F with

adequate cross-section.

WARNING! Before you connect

the mains cable to the terminal,

measure the voltage between

phases in the house network.

Then, refer to the connection

label at the back of the

appliance to use the correct

electrical installation. This order

of steps prevents from

installation errors and damage

to the electrical components of

the appliance.

WARNING! The power cable

must not touch the part of the

appliance shown in the

illustration.

22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Komentarze do niniejszej Instrukcji

Brak uwag